Automatic Garage Door Code

Arduino/Automatic Garage Door Code

@@ -0,0 +1,53 @@
+
+/*
+ Stepper Motor Control -Automatic Garage_Door
+
+ This program drives a unipolar or bipolar stepper motor.
+ It will close the door for '1' input and open the door for '0' input.
+ */
+
+#include <Stepper.h>
+#include <SoftwareSerial.h>
+
+
+SoftwareSerial BT(0,1);
+// creates a "virtual" serial port/UART
+// connect BT module TX to D0
+// connect BT module RX to D1
+// connect BT Vcc to 5V, GND to GND
+const int stepsPerRevolution = 200;  // change this to fit the number of steps per revolution
+                                     // for your motor
+
+// initialize the stepper library on pins:
+Stepper myStepper(stepsPerRevolution, 5,6,9,10);
+
+void setup() {
+   BT.begin(9600);  // set the data rate for the SoftwareSerial port
+   myStepper.setSpeed(60);  // set the speed at 60 rpm
+   Serial.begin(9600);  // initialize the serial port
+}
+char a; // stores incoming character from other device
+
+void loop() {
+   if(BT.available())
+   {
+     // if text arrived in from BT serial...
+     a=(BT.read());
+     if(a=='1'){
+          Serial.write(a);
+        //clockwise direction
+        for(int i=0;i<=8;i++)//{
+          myStepper.step(stepsPerRevolution);
+          //delay(20);}
+        BT.write('1');
+     }
+     else if(a=='0'){
+         Serial.write(a);
+         // anti-clockwise direction
+        for(int i=0;i<=8;i++)//{
+          myStepper.step(-stepsPerRevolution);
+          //delay(20);}
+        BT.write('0'); 
+     }
+   }
+}

Self Stabilization Platform

@@ -0,0 +1 @@
+This is the complete